Helldivers 2 Message Board  

the trainer and bypass works if you follow the directions

Link

[Edited by moderator Nook, 10/6/2024 9:14:44 PM]

Any guidance for my issue? I did try deleting the bin folder and reverifying and doing all the same steps again to no avail.

from the steps you posted on the last page you didn't follow the directions. You would need to launch the game from steam and then the launcher

I see. I made the mistake of thinking I had to close the game after the first launch with Steam and walking around. I'll try again later without closing the game and report back. Sorry about that.

There is some issue now ..
Normal start in steam works fine, no issue.
Start it with the launcher, hear the beeps, game starts .. cannot skip the cinematic, its like my keyboard doesnt work in the game.
When the cinematic ends, game says there is an error and trying to connect to servers. Wont enter the ship.

Quit, started the game on steam, no issue.
Tried it again with launcher, still same issue.

Are using the launcher while in-game as the new instructions says?

Just to clear up, the bypass does not work for me when following the instructions in the readme. Though in the replies there is a method to force it to work in a slightly different way while the game is still running. This leads to a certain crash for me about 10 minutes in every time. If the bypass could be inspected and changed slightly to work again as instructed that would be great.

Appreciate the effort trainer makers, thanks.

DONT
START
WITH
LAUNCHER

CRY, CRY, CRY

WE
POSTED
NEW
INSTRUCTIONS

this is the ONLY instructions, and if this doesn't work, there are no new instructions..

Run Aurora. Go to latest Helldivers 2 trainer. Download the latest LAUNCHER.
CLose Aurora

Put launcher in game directory, usually here:

C:\Steam\steamapps\common\Helldivers 2\bin

Run game NORMALLY through STEAM.

Skip the intro video.

Once you are ON THE SHIP, go to the directory and run the launcher. I know it sounds backwards, but do it.

Wait three beeps, almost instant.

Run Aurora again. Run the trainer, Activate Trainer.

There are no new instructions.

We've had 5000+ downloads of the latest trainer. If there are some rare machines that STILL this won't work for, it's something unique on your machine, like antivirus or antimalware, or some other setup that is causing the bypass to fail.

I don't have any other suggestions.

best,
Cal