I am running the game and both steam and the game are in offline mode. I have gone step by step to eliminate any issues. When I try to activate the trainer, I get the failed sound and the trainer doesn't work. The script I get is listed below. Does this indicate something specific I have not done or can do to make the trainer work?
18:03:56: ELDEN RING, 1.12.3 + Shadow of the Erdtree V2 (STEAM), Last modified: 07/08/2024 03:45:10
18:04:04: Successfully attached to eldenring
18:04:04: Module Engine: Failed checking at CreateToolhelp32Snapshot
18:04:04: runes, Script error in line 7: The module name '$process' does not exist!
Try to verify the game.
After that is done and it has replaced the file again, go into your AV and exclude your Aurora folder from scans, and also the folder where to file that follows is placed.
Reboot your PC, then start from scratch with the instructions in the readme.
Also make sure Aurora is running as admin.
Hi, just a quick question about how to play online again safely with a NEW character that has NOT been cheated on in any way?
I completed the game using the trainer on one character with which i used this trainer, i'd now however like to make a NEW character and play online with a friend in co-op (without the trainer)..
Do i need to remove the file i placed in the installation folder as per the original instructions and restore the official file first, or can i just make a new character and switch back to online with the "modified" file still there?
Thanks!
[Edited by NWill94, 7/29/2024 3:10:13 PM]
Verify or reinstall the game so that any files or edit done are cleared fully.
Ich habe das selbe Problem,
18:04:04: Module Engine: Failed checking at CreateToolhelp32Snapshot
18:04:04: runes, Script error in line 7: The module name '$process' does not exist!
ich weis auch nicht so genau was ich tun soll, welche Datei soll ich ersetzen?
I have the same problem,
18:04:04: Module Engine: Failed checking at CreateToolhelp32Snapshot
18:04:04: runes, Script error in line 7: The module name '$process' does not exist!
I don't know exactly what to do either, which file should I replace?
Read the instructions on the first post here or on the readme page at the trainer in Aurora. it is all explained.
Ich habe das selbe Problem,
18:04:04: Module Engine: Failed checking at CreateToolhelp32Snapshot
18:04:04: runes, Script error in line 7: The module name '$process' does not exist!
ich weis auch nicht so genau was ich tun soll, welche Datei soll ich ersetzen?
I have the same problem,
18:04:04: Module Engine: Failed checking at CreateToolhelp32Snapshot
18:04:04: runes, Script error in line 7: The module name '$process' does not exist!
I don't know exactly what to do either, which file should I replace?
Read the instructions on the first post here or on the readme page at the trainer in Aurora. it is all explained.
Yes, I have read it, but where can I find the attached file, that is the crucial point, unfortunately my English is not so good that I can express myself better
Important Board Topics
Trending Topics