LEGO Marvel Avengers Message Board  

DOWNLOAD TRAINER: Link

Options (Trainer)
-------

Numpad 1: Infinite Health
Numpad 2: Add 5000 Bricks
Numpad 3: Super Speed
Numpad 4: Fly Mode
Numpad 5: Freeze Race Timer


Options (Editor)
-------

Edit: Speed
Edit: Bricks


Notes
-------
- Fly Mode:
While active your characters are pushed into the air and stays there until
you deactivate this option. This will let you pass rivers and other things.
But it not let you pass cliffs etc, but your AI controlled character may
pass them. This means if you have fly mode active and be blocked by an
invisible wall before a cliff, your AI character may have passed this
invisible wall so all you have to do is to deactivate this option and quickly
switch your character to your AI controlled character.


Troubleshooting
------------------
The trainer requires .NET framework 4.5 or above.
The trainer does not work on Vista or older.
www.cheathappens.com/trainer_troubleshooting.asp

[Edited by PWizard, 1/27/2016 3:14:02 PM]

I have noticed that when using the add bricks option it only gives you 99% True Avenger even though you have more than the needed amount of studs.

Please Note: I used the editor to make the value 10,000,000 when I press it.

Other than that, Thanks for doing this so quickly and keep up the good work

What Psycho said below

[Edited by IKarlosI, 1/27/2016 4:19:48 PM]

Have you collected some bricks after using the add brick option? Perhaps you need to trigger the 1% yourself?

The Trainer won't activate even if the game is running why does the trainer do that?

It's hard to guess with zero information. Does the trainer find the process? You can see at the trainers main page at the bottom, it will say "Status: Waiting for" or "Status: Found". If it does not find the process then you might have launched a DX9 version or anything else except the trainer is looking for.

If it does find the trainer then you might tell me if you hear any sound when pressing F1. If not, have you accidently turned on the controller mode?

The possibilities are same as if you tell the doctor "It hurts, why does it hurt?" he can try to start from A to Z of the medical problems or, you going to tell him what exactly hurts and what has changed.

Hi 0x90

Regarding the trainer for Lego Marvel Avengers the trainer works fine for me but when I collected some studs and then add more bricks it goes to 99% and wont give you the 100% needed even after I'm at 99% and collected more studs it wont jump to 100%.

Is there away to fix it so you can reach 100% even before or after you collect studs? thanks for the trainer hope this info helps

[Edited by Psycho Gamer, 1/27/2016 2:48:53 PM]

When i launch the trainer it says "Status: Waiting for" then i go to steam and launch the game. After the game is launched the trainer stil says "status: waiting for, do i have to go into the main folder of the game and launch the dx11 version, or is it enough that i launch the game from steam?
Hope this is better information.

It looks for the DX11 executable. I think you can change the DX version in the game options. It requires a DX11 ready graphic card of course. If the game still launches by the other executable then there is nothing I can do for you. The trainer is written for the DX11 version.